Awning-02

1) Remove screws that run through the awning rail into the fabric. 2) Remove the lag screws from the front and rear upper brackets. 3) Slide the entire awning assembly out of either end of the awning rail.
7) Use a 3/16-inch bit to drill out the rivets holding the spring assemblies in place. 8) Before removing each spring assembly, mark the end and the roller tube for reinstallation. 9) Pull the spring assembly away from the roller and set aside for later installation.
- Advertisement -

Products

Parkit360 Transformer

Moving Experience

Getting travel trailers into tight spots is simple and safe with the Parkit360 dolly Few things intimidate some trailer owners more than backing into a...

At Your Doorstep: MORryde StepAbove

MORryde’s retractable stairs make getting into and out of an RV a breeze, and they flip up for travel Not much has changed in the...

Truck-Bed Protection: Tonneau Covers and Bed Liners

Enhance the look of your truck with these worthwhile investments that pay off and shield valuable cargo Whether you bought a truck for towing, work-related...