mike-uswest
Central Point, OR, USA
Senior Member
Joined: 06/27/2002
View Profile
Good Sam RV Club
 Offline
|
I finally got time to put in my digital thermostat, only after the old duo-therm gave up the ghost and left us in the cold with upper teens outside. I did have an Olympian 6100 and the stove burners to help. Anyway, thanks for the help before, it is in and working fine. My question now is the Duo-therm had a high and low fan position, and others talk about putting in a switch to accomplish this from Radio shack on the digital. The only wire that I did not use on the new thermostat was the "H" wire, that I was told was a hot wire. It is a blue wire on mine, that doesn't match what others have said, but I understand that this can often be not to code. I don't have any other wire to put to a selective switch for high or low on the fan. I have the "RH", "RC", "W", "Y", and "G" switched to the appropriate place on the digital, and the only one left is the one that was hooked to "H". Also what is the main reason for the two speed fan, is it necessary? Thanks.
Mike
2003 Dodge 2500 CTD, 4X4,
1994 Alpenlite 26'fifth wheel
See picture in profile.
|
