Step 2: Drill out the center hole (switch shaft) and smaller outer hole (for lock pin) using the BD VVB decal as your guide.

Step 2: Drill out the center hole (switch shaft) and smaller outer hole (for lock pin) using the BD VVB decal as your guide.

Step 1: Run the wires from the control switch from the engine compartment into the cab on the driver’s side. Then carefully pop loose the upper left dash panel.
Step 3: Drill out the center hole (switch shaft) and smaller outer hole (for lock pin) using the BD VVB decal as your guide.
- Advertisement -

Products

Handy Hitch Tote

It’s hard to find a good location to store a cumbersome weight-distribution ball mount and spring bars where they are easy to access yet...

Steered Straight

Full-size Chevy and GMC pickups, vans and SUVs from 2001 to 2010 may suffer from lazy steering, inducing premature component and tire wear as...

See the Light

Having extra illumination in and around the RV is always handy, particularly in the dark recesses of closets, cabinets and exterior storage compartments. Light...