10-Minute Tech: Never Without a Vise

RV How Tos: Portable Vise

I made a bracket on which to mount a swivel vise. The bracket is made with 2-inch square tubing and fits in a standard 2-inch receiver. I used a 19-inch steel tube coming out of the receiver squared up to a 13-inch tall vertical tube. For support, I welded an 11-inch long sheet steel bracket at an angle between the two pieces. On top of the vertical piece, I welded on a 6-inch square plate, in which I drilled three holes to mount the vise with 3/8-inch bolts. Don’t forget to drill a 5/8-inch hole on the long horizontal piece for the pin in your hitch receiver. 

William Bouma, Wildwood, Illinois


To send your submission, write to 3300 Fernbrook Lane N, Suite 200, Minneapolis, MN 55447. Or visit our contact us page and send a letter directly to the editor.

LEAVE A REPLY

Please enter your comment!
Please enter your name here