24_DSC_0027

1) Jack stands are needed to support the frame and allow the suspension to hang. The trailer must not be lifted by the axles, which are stabilized only with floor jacks.
23) Spring end is pivoted until relatively level and on the pipe spacer that will be positioned inside the center box.
25) Bolts go through the specified holes in the center box from the inside to allow clearance for the shocks that will be installed later. Thread locker is applied, and bolts are torqued to the specified values printed in the instructions.
- Advertisement -

Products

A happy camper demonstrates the Skreenz, vehicle screens for RVs

Staff Pick: Skreeenz Vehicle Screens

We love camping but don’t love biting bugs. To keep them out of our Class B motorhome, we ordered Skreenz, tough-as-nails mesh insect screens...
closeup of butterfly on a flower

Sponsored Content: Tamron’s Vibration Compensation Is Key to Performance of 18-400 Zoom

With its 22.2x zoom, versatile focal-length range, and maximum magnification ratio of 1:2.9, the Tamron 18-400 all-in-one ultra-telephoto zoom allows you to shoot everything...
The Micro-Air EasyStart system

Micro-Air EasyStart: This Is Cool!

Micro-Air’s EasyStart reduces the power requirement to start and run rooftop air conditionersA frustration that trailerists have been grappling with for decades is the...