Make a Stand

10MT-water-filter-holder

November 2, 2015
Filed under 10-Minute-Tech

 

I made a simple stand to hold the filter I use for the water entering the RV using some scrap 2×4-inch lumber and PVC conduit. This comes in handy at paved and concrete campsites where I can’t get the original stand to stick in the ground. Simply take two short pieces of ½-inch PVC conduit and hammer them into holes that are drilled slightly undersized in a wooden stand made from the scrap lumber.

Scott Eggers | Villas, North Carolina

 


 

Print Friendly

Related Content

Last 5 stories in 10-Minute-Tech

Other stories that might interest you...

Comments

Feel free to leave a comment...
and oh, if you want a pic to show with your comment, go get a gravatar!





Get a FREE issue of Trailer Life Magazine

Sign up for your trial subscription and you'll receive a FREE issue. If you like Trailer Life, pay just $17.97 for 11 more issues (12 in all). Otherwise, write "cancel" on the invoice, return it and owe nothing.

Terms of Use | Privacy Policy

© 2016 Good Sam Enterprises, LLC. All Rights Reserved.