Chock It Up


June 29, 2015
Filed under 10-Minute-Tech, Resources


I went to my local Lowe’s and got a twisted/bent 4×6-inch piece of wood that was 16 feet long. In speaking with the store manager, I was able to get it for only $5, since it was a piece of scrap wood. I cut two pieces to 13-inch lengths and mitered the corners to 45 degrees to fit between my trailer’s tires. They don’t have to fit too tightly; just leave a little space so they won’t be too snug on uneven ground. I put an eye hook in each block, so I can use our RV’s awning wand to pull the blocks out without even bending over.

I then cut the rest of the 4×6-inch lumber into leveling blocks for under the jacks after making two sets of chocks for my friend’s trailer. These literally cost me less than a couple of bucks for each set, and they work well going forward or reverse. I’ve seen people with rubber mallets hammering chocks so they don’t pop out. Not me; I just set them in between the tires.

Mark Wisor | Madera, Pennsylvania



Print Friendly

Related Content

Last 5 stories in 10-Minute-Tech

Other stories that might interest you...


Feel free to leave a comment...
and oh, if you want a pic to show with your comment, go get a gravatar!

Get a FREE issue of Trailer Life Magazine

Sign up for your trial subscription and you'll receive a FREE issue. If you like Trailer Life, pay just $17.97 for 11 more issues (12 in all). Otherwise, write "cancel" on the invoice, return it and owe nothing.

Terms of Use | Privacy Policy

© 2016 Good Sam Enterprises, LLC. All Rights Reserved.