RV Entry Steps

RV Entry Steps

September 6, 2012
Filed under Trailer How To

In order to eliminate slipping on our entry steps, and also to trap dust and mud, I designed simple removable step pads that are held in place with magnets. I purchased inexpensive carpet ends (or remnants) at a local carpet store. The cost is minimal and it is not difficult to find a color to match the rig’s exterior. Then I purchased eight round magnets, ¼-inch thick and 1 ½ inches in diameter, for each step. After cutting the carpet to the exact measurement of the top surface of each step, I glued eight magnets to the underside of each newly cut step pad. It’s important to use waterproof adhesive. I used Goop.

To prevent the carpeting from unraveling, I lightly applied a flame from a propane torch to the edges. Once the adhesive hardens, the pads can be positioned on the steps. These pads provide a soft, cushioned, nonslip surface that will trap dirt and dust. When we hit the road, the pads are removed and stored just inside the door. When the pads become too soiled for long use, I take off the magnets and glue them to newly cut pads. The whole job costs around $12.

—Dexter Blindbury, Chico, Calif.

To send your submission visit our contact us page and send a letter directly to the editor.

Print Friendly

Related Content

Last 5 stories in Trailer How To

Other stories that might interest you...


Feel free to leave a comment...
and oh, if you want a pic to show with your comment, go get a gravatar!

Get a FREE issue of Trailer Life Magazine

Sign up for your trial subscription and you'll receive a FREE issue. If you like Trailer Life, pay just $17.97 for 11 more issues (12 in all). Otherwise, write "cancel" on the invoice, return it and owe nothing.

Terms of Use | Privacy Policy

© 2016 Good Sam Enterprises, LLC. All Rights Reserved.