TwoWayAir-07

The 2wayair kit for six tires comes standard with two small sections of protective polyethylene tubing, 40 feet of black 3/8-inch polyurethane manifold tubing, 15 feet of 1/4-inch black polyurethane tubing, 24 feet of yellow polyurethane “whip” tubing plus UV-rated mountable and standard nylon ties, and an assortment of push-to-connect and quick-disconnect fittings and patent-pending mountable Schrader valves.
(12) The main 3/8-inch manifold tubing is run along an existing wiring loom and secured with supplied nylon ties. The stiff polyethylene tubing is used to cover the manifold tubing to prevent chafing wherever a tie is used. Alternately, the manifold tubing can be secured by drilling 3/16-inch holes along the plumbing route and the mountable cable ties used. The polyurethane tubing has a temperature limit of 160 degrees, so make sure to route it away from heat sources. The 3/8-inch manifold tubing is then cut near the front wheel, and the 3/8-inch to 1/4-inch T installed (arrow). The 1/4-inch tubing is routed to the front Schrader valve mounted earlier. (13) Here you can see the route from the main 3/8-inch manifold tubing to the T-fitting and the 1/4-inch tubing running to the front Schrader valve. The process is then repeated on the other side of the vehicle. (14) All of the manifold tubing converges at the control panel under the hood. The 3/8-inch manifold tubing from either side of the vehicle is tied to the main control valve with a 3/8-inch T-fitting. All of the peripherals — i.e. the gauge, the Schrader valve, the pressure relief valve and the onboard air line — T into the main manifold. It’s easier to install than it is to explain, believe us. The air compressor was then plumbed into the system with a male D-type quick-disconnect fitting and 1/4-inch FIP by 1/4-inch OD push-to-connect adapter. The user now has three options for airing-up (female D-type from an air hose, the Schrader valve or the onboard air compressor that is plumbed in).
- Advertisement -

Products

Carefree of Colorado’s Awning Extend’r can be installed on manual or electric awnings. When staked down, the straps not only support the extension canopy but also help stabilize the existing patio awning from the wind.

Made for Shade: Carefree Awning Extend’r

Carefree’s easy-to-install fabric Awning Extend’r can nearly double canopy coverage In one way or another, RVers seem to be in a constant battle against the...

Solar Charged: Victron System from AM Solar

Keeping batteries charged while dry camping can be a challenge unless an AC generator is powered up. A smart alternative is a Victron Complete...

Pump Up the Volume: Flow Max Water Pump

Larger RVs sometimes have issues with good water pressure in fixtures farthest away from the freshwater tank and pump. Duraself’s 12-volt DC Flow Max...