26_DSC_0037

1) Jack stands are needed to support the frame and allow the suspension to hang. The trailer must not be lifted by the axles, which are stabilized only with floor jacks.
25) Bolts go through the specified holes in the center box from the inside to allow clearance for the shocks that will be installed later. Thread locker is applied, and bolts are torqued to the specified values printed in the instructions.
27) Original U-bolts will need to be closed slightly to fit in the new tie plates. This can be done by placing the nuts on the ends and hitting with a hammer while on a solid surface.

Products

Cummins Onan P4500i and P2500i

Carry-Out Power

With a new pair of portable inverter generators, Cummins Onan enters the market in a big way The year was 1961, and Onan produced the...
Camping World Zig Zag Zero Gravity Recliner

Staff Pick: Zig Zag Zero Gravity Recliner

A big part of RVing is relaxing, and finding just the right chair makes down time so much better. It’s hard to beat the...
HitchGrip Hitch-Ball Mount Carrier on hitch ball

HitchGrip Hitch-Ball Mount Carrier

My husband does the hooking and unhooking of our travel trailer when we go camping. He always complains about having to use gloves to...